Environment - Festool Carvex SC 420 EB Operating Manual

Adaptation to the circle cutter
The circle cutter can be used to create circular cuts
with a diameter between 120 and 3000 mm. The cir-
cle cutter can be installed from both sides on the
adaptation table.
Place the jigsaw with attached adaptation table

on the adapter [10-1] on the circle cutter.
Insert the centring mandrel [10-2] in the hole

[10-4] on the circle cutter aligned with the saw
blade.
Clamp the measuring tape to the circle cutter

using the rotary knob [10-5].
Recommended when using the circle cutter:
Cut in an anticlockwise direction.

Work at a slow rate of advance.

PSC 420 EB, PSBC 420 EB
Set the pendulum stroke [1-11] to 0 - 1.

Set the stroke rate [1-5] to 1 - 5.


Store the centring mandrel in the depot [10-3].
11

Environment

Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh: www.festool.com/reach
GB
21