Mounting Position; Conditions On Site; Mechanical Installation - HBM TB1A Mounting Instructions

Hide thumbs Also See for TB1A:

Table of Contents

Available languages

4.2 Mounting position

The reference torque measuring disc can be installed in any position. With

clockwise momentum, there is a positive output signal in conjunction with the

HBM measuring amplifiers.

The TB1A reference torque measuring discs are protected to IP54 according

to EN 60529. The measuring discs must be protected from dirt, dust, oil,

solvents and humidity.

During operation, the prevailing safety regulations for the security of

personnel must be observed.

NOTE

Handle the reference torque measuring disc carefully. The transducer

might suffer permanent damage from mechanical shock (dropping),

chemical effects (e.g. acids, solvents) or thermal effects (hot air, steam).

CAUTION

You must not loosen the screwed joints of the measuring body and

mounting flange and the slotted screws of the identification plate

marked at the factory by safety paint.

HBM

TB1A

A0162 7.0 en/de/fr

Table of Contents

Table of Contents