Advertisement
Tighten the attachment nut firmly onto the water selection
unit (Fig. 1).
Make sure the rubber washer is firmly pushed against the tap to prevent
water leakage.
Connecting the hose to the water selection unit
1
Make sure the tap is closed.
Set the water selection lever to the unfiltered stream
position (Fig. 19).
Cut the hose to the required length (Fig. 0).
Remove the hose joint from the water selection unit (Fig. 1).
5
Push the hose through the hose joint (1). Push the hose onto the
connection point until it does not go any further () (Fig. ).
6
Tighten the hose joint (Fig. ).
Use the nylon fasteners to fasten the hose along the tap (Fig. ).
Using the water purifier
The water selection unit has 4 settings: filtered spray, filtered stream,
unfiltered spray and unfiltered stream.
-
The unfiltered spray and stream come out of the water selection unit.
-
The filtered water comes out of the swivel nozzle. The swivel nozzle
has two settings: filtered spray and filtered stream.
Do not let water hotter than 50°C run through the water purifier, as
this may damage the water purifier.
Filtered water (spray or stream)
Select this setting for drinking, washing vegetables or fruits and
for cooking.
1
Turn the swivel arm to the desired position.
Turn the water selection lever on the water selection unit until the
filtered water symbol is aligned with the indicator (Fig. 25).
EnglisH
11
Advertisement
