Mitel 420 Quick Install Manual

Connecting a Headset (Optional)
The IP Phone supports use of an optional Headset, as shown. After connecting the headset,
select the Headset button on the front panel of the IP Phone.
Adjusting the Viewing Angle of the Phone
(Optional)
The IP Phone stand supports two tilt angles for the phone on desk.
The stand is shipped in the low position. Use these instructions to change the tilt angle.
Remove the Stand:
1. Disconnect the handset cable from the rear of the IP Phone and pull it out from the side of
the stand. Set the handset aside.
2. Grasp the phone base in one hand and the stand in the other. Pull the stand off the base
until it unsnaps.
Replace the Stand:
1. Rotate the stand 180 degrees. Seat the stand firmly in the hooks.
2. Push the stand into the base until it snaps into place.
3. Rethread the handset cable through the side of the stand and reconnect the handset.
Low angle
2
1
Remove
Copyright © 2017 Mitel Networks Corporation. All Rights Reserved. The Mitel word and logo are trademarks of Mitel Networks Corporation.
Any reference to third-party trademarks is for reference only and Mitel makes no representation of ownership of these marks.
4
2
High angle
1
3
Replace
Part Number: 800-1541-10
IP Phone
420/420g
Quick Install Guide
Connecting to Power over Ethernet
Required Items:
Ethernet cable for IP Phone (included)
l
Network wall port that supports power or Power over Ethernet (PoE)
l
Note: This configuration describes a Power over Ethernet connection. Refer to Connecting to Power
and the Network on page 2 if your network wall port or data switch does not support Power over
Ethernet.
2
Connect Power over Ethernet:
1. Connect one end of the Ethernet cable to the Ethernet port on the IP Phone.
2. Connect the other end of the Ethernet cable to a network wall port that
supports Power over Ethernet. After a few seconds, the IP Phone
powers on and runs through a series of system tests.
Note: This IP Phone supports 10/100 Ethernet network speed.
1
1