Assembly Instructions; Scope Of Delivery; Fitting The Wheels; Mount The Control Element - Grizzly EGT 1440 Instructions For Use Manual

16 Motor housing
17 Carrying handle
18 Device cable
19 2 cable clamps
20 Cable relief
21 Gears
22 Drive shaft

Assembly instructions

Always disconnect the tool from the
mains before conducting any work on it.

Scope of delivery

Carefully remove the tool from the packag-
ing and check that the following parts are
complete:
- Motor housing with cutting blade and
control element
-
Upper grip handle
- Middle handle bar
- Mounting accessories for handle mount-
ing
(4 tightening levers, 4 washers, 4 screws)
- 2 wheels
- Mounting accessories for wheel mounting
(2 hubcaps, 2 screws, 2 washers,
2 spring washers)
- 2 cable clamps
- Translation of the original instructions for
use

Fitting the wheels

1. Put a wheel (14) on the wheel
axle (14a) so that the hub cap is
facing outwards.
2. Screw the wheel (14) on to the
device. To do this, use the en-
closed screw (14c), spring wash-
er (14d) and standard washer
(14e).
3. Press the end cap (14b) on the
wheel.
4. Mount the second wheel in the
same way.

Mount the control element

1. If necessary, loosen the 4
screws (1a) on the control ele-
ment (1) and remove the handle
cover (1b).
2. Press the end of the upper han-
dle bar (6) into the control ele-
ment (1) so that the holes in the
upper handle bar fit into the pins
on the control element (1).
Make sure that the cable of the
device (18) is not twisted.
3. Put on the handle bar cover
(1b) and screw it tight with the
4 screws (1a).

Mounting the grip rod

Make sure during assembly that
the device cable is not pinched
and has enough play.
Mounting the middle handle
bar:
1. Position the curved end of the
middle handle bar (9) between
the lower handle bar (11).
2. Attach the middle handle bar
with the screws (10), washers
(10b) and clamping levers (10)
supplied.
3. Turn the tightening levers (10)
clockwise.
4. Lock the tightening levers (10)
by pressing them in the direc-
tion of the middle handle (9).
The tightening levers must be
positioned against the handle
UK
73