Assembly Instructions; Fitting The Wheels - Grizzly EGT 1545 Original Instructions For Use

to improve its working safety
and effectiveness.
• Follow the maintenance regu-
lations.
Electrical safety:
Warning! Do not use the tool
if the mains or extension ca-
ble is damaged – danger of
electrical shock.
• Keep the mains cable away
from the tines. Always trail the
mains cable behind you or the
person operating the tool. If the
cable becomes damaged dur-
ing use, immediately discon-
nect it from the mains.
Never touch the mains cable
before unplugging it from
the mains.
• Make sure that the mains volt-
age matches the data on the
tool's rating label.
• Avoid skin contact with earthed
objects such as metal fences
and posts.
• Make sure that the connector
on the extension cable is pro-
tected from splash water, and is
made of rubber or has a rubber
covering. Only use extension
cables that are intended for
outdoor use and are labelled
as such. Use extension cables
with a cable core diameter of
at least one square millimetre.
Always completely unwind the
cable reel before use. Check
the cable for damage.
• Use the cable hanger fitted for
the purpose when using an ex-
tension cable.
• Do not carry the tool by the ca-
ble. Do not unplug the cable by
tugging on it. Keep the cable
away from heat, oil and sharp
edges.
• Only connect the device to a
socket with a residual current
device (RCD) with a rated re-
sidual current of not more than
30 mA.

Assembly instructions

Always disconnect the tool from
the mains before conducting any
work on it.
While assembling the tool, make
sure that the mains cable (2)
does not become caught and has
enough slack.

Fitting the wheels

1. Fasten the wheel rod (12) to the
underside of the device using 2
hexagon socket screws and 2
nuts.
2. Slide the wheel axle (13)
through wheel rod (12).
3. Fasten the wheel axle (13) us-
ing the butterfly screw (17) and
the wing nut (18) at the desired
working height.
There are 4 possible positions.
4. Put a wheel (14) on the wheel
axle (13) so that the end cap
(20) is facing outwards.
5. Fasten the wheel (14) to the
wheel axle (13) using the en-
closed splint (19).
6. Press the end cap (20) onto the
wheel (14).
7. Mount the second wheel in the
same way.
GB
71