Operation; Working Position/ Transport Position; Switching On And Off - Grizzly EGT 1440 Instructions For Use Manual

UK
such that tightening can be car-
ried out with medium force.
If this fails, continue to turn
the tightening lever clockwise,
or loosen it by turning counter
clockwise (see small image).
Mounting the upper handle:
5. Position the curved end of the
upper handle (6) between the
middle handle (9).
6. Attach the upper handle (6) with
the screws (7a), washers (7b)
and clamping levers (10) sup-
plied.
7. Lock the clamping levers as de-
scribed under 3. and 4.
Clipping in cable clamps:
8. Clip in the cable clamps (19) to
the middle handle (9) and use
these to fix the device cable
(18) in position.
If you release the clamping levers
(7/10), you can fold down the up-
per handle (6) and the middle han-
dle (9) to store the lawnmower.

Operation

Observe noise-abatement laws and
local by-laws.
Working position/
transport position
The wheels can be adjusted in
2 ways:
Œ
Transport position: The wheels are
folded down, the device is mobile.
Working position: The wheels are

folded up. The device is ready for use.
74
Setting the working position:
1. Tighten the wheel adjustment
ring (12) and fold the wheels (14)
upwards.
2. Release the wheel adjustment
(12). The locking pin snaps into
the upper hole (11a) on the lower
handle (11).
Setting the transport position:
3. Tighten the wheel adjustment
ring (12) and fold the wheels
(14) downwards.
4. Release the wheel adjustment
(12). The locking pin snaps
into the lower hole (11a) on the
lower handle (11).

Switching on and off

Note: Before switching the tool
on, make sure that the tool is not
touching any other objects and
hold it firmly in both hands.
1. Plug the tool into the extension
cable.
2. For cable strain relief, form a loop
in the end of the extension cable
and hang it into the cable relief
(20).
3. Connect the equipment to the
mains power supply.
4. To switch on, press the release
button (2) on the handle then the
starting lever (3). Release the
release button (2).
The cutting blades start to rotate
and dig into the ground.
5. To switch off, release the starting
lever (3).