Advertisement
___
Install the 2 SPST toggle switches (S1 & S2) in the chassis in the power and the auto positions.
Remove the nut and one washer from the switch. Place the switch in the hole with the 2 prongs
toward the bottom. Then replace the lock washer and nut on the switch. You may need to re-
align the switches later, so don't tighten yet.
___
Install the 2 SPDT momentary switches (S3 & S4) in the chassis in the CAP and the IND
positions. Remove the nut and one washer from the switch. Place the switch in the hole. Then
replace the lock washer and nut on the switch. You may need to re-align the switches later, so
don't tighten yet.
___
Install the 1 push-button switch (S5) in the tune position. Remove the nut and washer from the
switch. Place the switch in the hole and replace the washer and nut on the switch. Be sure the
solder terminals of the switch are aligned one on top of the other. You may need to realign the
switches later, so don't tighten yet.
___
Place the LEDs in the front panel board, LED1 Green, LED2 Yellow, LED3 & 4 Red. Be sure to
place ground leg down. The ground leg of the LED is the one with the notched plastic next to it.
Do not solder them at this time.
___
Install the Front Panel PC Board on the switches. The side without the white silk screen will be
placed on the solder terminals of the switches. Gently push the PC board onto the switches. The
LEDs should slide into the holes in the chassis. They should be in this order -- Tune Switch,
Green, Yellow, Red and Red. Once you have checked the alignment, then solder the switches to
- 11 -
Advertisement
