Advertisement
___
Install a two inch length of left over #24 wire left over from winding the inductors through the hole
in T1. Be sure to scrape the thermaleze coating off of the ends of the wire before soldering.
Solder this from beneath the circuit board. Attach one SO-239 to the other end of this wire. Cut
another 1 ½ inch length of wire for the antenna connection. Solder one end to the PC board next
to L8, and then attach one SO-239 to the other end.
___
Using left over pieces of #24 gauge wire, cut one piece 1 ¾ inches – for J1, and one 1 ¼ inches
long – for J2. Crimp the terminal lugs onto one end of each of the wire, and attach the other ends
to the PC board at J1 & J2. At this time go ahead and solder the terminal lug to the wires to insure
a good ground. Be sure to scrape the insulation off the wires so they can be soldered.
You are finished with the assembly of the main PC board. Proceed with the assembly of the front panel
PC board.
___
Install the 14 pin header with 0.1 inch spacing to the side of the front panel PC board that has the
white silk screen. Solder the shorter ends of the pins to the PC board.
___
Install the resistors on the opposite side of the PC board as the header (either side will actually
work). R1 & 2 are 470 ohm 1/8 watt resistors (yellow-violet-violet). R3 & 4 are 100 ohm 1/8 watt
resistors (brown-black-brown).
___
Unwrap the chassis of the enclosure (the one with the white silk screen writing on it) and put the 4
rubber feet on the bottom. Take care not to cover the wholes that are there. These are used when
mounting the PC board in the chassis.
- 10 -
Advertisement
