Related Manuals for Ingersoll-Rand 2925B2Ti
Summary of Contents for Ingersoll-Rand 2925B2Ti
- Page 1 04584355 Edition 3 January 2014 Air Impact Wrench 2925B2Ti and 2925RB2Ti Maintenance Information Save These Instructions...
-
Page 2: Product Safety Information
Note: When reading the instructions, refer to exploded diagrams in Parts Information Manuals when applicable (see under Related Documentation for form numbers). Lubrication Each time a Series 2925B2Ti Impactool is disassembled for 2. Use Ingersoll Rand No. 10 Oil for lubricating the motor. maintenance and repair or replacement of parts, lubricate the tool... -
Page 3: Disassembly Of The Motor
4. Use a hooked tool to remove the Reverse Valve (10) from the 4. Place the assembled motor on a clean bench with the rotor spline reverse valve bushing. Set the Reverse Valve aside on a clean facing upward. bench. 5. -
Page 4: Assembly Of The Impact Mechanism
(Dwg. TPD2023-1) (Dwg. TPD2023-1) Assembly of the Impact Mechanism Assembly of the Reverse Valve 1. Coat a new Reverse Valve O-ring (6) with O-ring lubricant and NOTICE install it in the groove on the Reverse Valve (10). 2. Install the Reverse Valve in the reverse valve bushing with the To ensure proper Reverse Valve operation, the Reverse Lever slotted end trailing, making sure that the index mark on the must stay in this position when installing the Backcap and... -
Page 5: Assembly Of The Tool
Assembly of the Tool NOTICE 1. Wipe a thin film of the recommended grease on the inside of the Hammer Case Bushing (42) and insert the assembled impact When installing optional Hanger Kit, place Gasket on the mechanism into the Hammer Case (43). Hammer Case followed by the Hanger. - Page 6 Notes:...
- Page 7 Notes:...
- Page 8 ingersollrandproducts.com © 2014 Ingersoll Rand...