Avalue Technology ARC-1532-C2 Quick Reference Manual page 54

ARC-1532-C2
Flow Control
VT-UTF8 Combo Key
Support
Recorder Mode
Resolution 100x31
Legacy OS Redirection
Resolution
Putty KeyPad
Redirection After BIOS
POST
54 ARC-1532-C2 Quick Reference Guide
None[Default]
Hardware RTS/CTS
Disabled
Enabled[Default]
Disabled[Default]
Enabled
Disabled[Default]
Enabled
80x24[Default]
80x25
VT100[Default]
LINUX
XTERMR6
SCO
ESCN
VT400
Always Enable[Default]
Boot Loader
with slow devices may require more than 1 stop
bit.
Flow control can prevent data loss from buffer
overflow. When sending data, if the receiving
buffers are full, a 'stop' signal can be sent to
stop the data flow. Once the buffers are empty,
a 'start' signal can be sent to re-start the flow.
Hardware flow control uses two wires to send
start/stop signals.
Enable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals.
With this mode enabled only text will be sent.
This is to capture Terminal data.
Enables or disables extended terminal
resolution.
On Legacy OS, the Number of Rows and
Columns supported redirection.
Select FunctionKey and KeyPad on Putty.
When Bootloader is selected, then Legacy
Console Redirection is disabled before booting
to legacy OS. When Always Enabled is
selected, then Legacy Console Redirection is
enabled for legacy OS. Default setting for this
option is set to Always Enable.