ROHO AGILITY Operation Manual page 4

Important Safety Information, Continued
Cautions:
- Protect your AGILITY from blunt force shocks that may cause damage and/or breakage.
- Use of any hardware or components other than those supplied by ROHO may result in product damage or failure and may void the
warranty.
- The components of the AGILITY are not intended to be used separately from an AGILITY or in conjunction with other wheelchair back
systems.
- Altering an AGILITY may affect its performance and void the warranty.
- Metal components may become hot if exposed to high temperatures or cold if exposed to low temperatures.
- You may need to remove your AGILITY before folding your wheelchair.
Warnings - Motor Vehicle Transportation
- Whenever possible, transfer out of your wheelchair installed with an AGILITY and into a manufacturer-installed vehicle seat, and
use the vehicle's crash-tested occupant restraint system.
- Failure to pay attention to these warnings could result in severe injury to the individual in the wheelchair or to others.
- The AGILITY must be correctly and securely installed on the wheelchair. Follow all provided instructions and warnings.
- Install an AGILITY on a wheelchair so the individual is seated in an upright position and the wheelchair is facing forward
during transportation in a motor vehicle. The AGILITY has only been crash tested on a wheelchair in the forward-facing position
per the test information provided in this operation manual.
- The AGILITY must only be used with wheelchairs that comply with the performance requirements of ISO 7176-19 and that are
installed, used and maintained according to the wheelchair manufacturer's instructions.
- The wheelchair with an AGILITY must be used with an effective wheelchair securement system and a properly positioned,
crash-tested pelvic and shoulder-belt restraint, or Wheelchair Tiedown and Occupant Restraint System (WTORS), following the
manufacturer's instructions.
- The top of an AGILITY should be positioned as close as possible to the top of the individual's shoulder to provide good support
in the event of a crash. The distance between the top of the individual's shoulder and the top of the wheelchair back should not
exceed 61/2 in. (16.5 cm).
- If an AGILITY is involved in a motor vehicle accident, see M
AGILITY with Fixed Hardware has been dynamically tested by a third-party testing facility for use in a motor vehicle and meets all
criteria for wheelchair seating systems proposed in Section 5.1.1 of Section 20 ANSI/RESNA/ WC/Volume 4 "Wheelchair Seating Systems
for Use in Motor Vehicles".
ROHO AGILITY Back System Fixed Hardware Operation Manual
aintenance
3
in this manual.