Honeywell Gamewell FCI S3 Series Manual page 56

System Configuration
8.3 S3 Series Module System Configurations
Table 8.3.1 lists the Modules required to make the S3 Series System Configuration.
SLP-E3
SLC-PM
SLC95-PM
LCD-E3
LCD-SLP
FLPS-7
FML-E3
FSL-E3
RPT-E3-UTP
DACT-E3
ASM-16
ANU-48
LCD-7100
RAN-7100
IPDACT
Y - Yes
O - Optional
## - Separately Listed (S1869), (S2464)
### - Separately Listed (S1949), (S1869)
#### - Separately Listed
NOTE 1: These items are modules that consist of the S3 Series control panel.
NOTE 2: These items may be remotely located from the Control Panel.
NOTE 3: One loop driver module is required per SLP-E3 minimum. Select SLC-PM for System
Sensor or select SLC95-PM for Apollo devices. The SLP-E3 supports the use of up to two SLC-
PM or SLC95-PM modules per SLC-E3. Only one type of loop driver module may be installed on
a single SLP-E3. DO NOT use one SLC-PM and one SLC95-PM on a single SLP-E3.
56
Module
Smart Loop Panel - Main Board
SLC-PM for System Sensor Protocol
SLC95-PM for Apollo Protocol
LCD Display sub-assembly
LCD Display-SLP sub-assembly
Power Supply
Fiber-Optic Multi-Mode
Fiber-Optic Single-Mode
Network Repeater sub-assembly
Digital Dialer Communicator Transmitter
Annunciator Switch Sub-Assembly
Annunciator Sub-Assembly
Remote LCD Display
Remote LCD Display
IP Digital Alarm Communicator
Legend for Codes in Required? Column
Notes Describing Codes in Required? Column
Table 8.3.1 S3 Series Module System Configurations
S3 Series UL Listing Document — P/N LS10005-051GF-E:D3 3/09/2016
S3 Series Module System Configurations
Description Required?
Y (See Note 1)
Y (See Note 3)
Y (See Note 3)
O (See Note 1, 2)
Y (See Note 1),
O (See Note 2)
Y (See Note 1)
O (See Note 1)
O (See Note 1)
Y (See Note 1)
O (See Note 1)
O (See Note 2)
O (See Note 2)
O (See Note 2)
O (See Note 2)
O (See Note 2)