Removing Blockages From The Turbotool; Changing The Belt - Vax MachAir UCA1GEV1 Quick Start Manual

Taking care of your machine

Removing blockages from the TurboTool

A
Using a crosshead screwdriver,
remove the 2 screws (A) to clean
the TurboTool.
WARNING: To reduce the risk of injury from moving parts, unplug from the mains before carrying out any maintenance.
The brushbar is equipped with bearings which contain sufficient lubrication for their lifetime. Do not add lubricant to
the brushbar.

Changing the belt

IMPORTANT: Unplug and switch off the vacuum cleaner before maintenance or troubleshooting checks.
Using a crosshead screwdriver,
remove the 3 screws from the belt
cover on the side of the floorhead.
Remove the cover (B). Clean
out any debris or hair from the
brushbar and turbine fan.
Pull to remove the belt cover.
Clean any debris from the spindle.
Place the new belt onto the spindle
and line up the teeth on the belt with
the teeth on the cog. Slide the belt
into place.
B
Replace the cover and
tighten the screws.
Pull to remove the brushbar location
plate. Remove the belt.