Removing Blockages - Vax U88-T4 Series User Manual

U88-T4-P User Guide v1.0 [J316]_User guide 20/04/2012 14:57 Page 9
Maintenance

Removing blockages

WARNING: To reduce the risk of electric shock, turn the vacuum cleaner off and unplug from the electrical
!
socket before performing maintenance/troubleshooting checks. Disconnect the hose from the vacuum
cleaner and remove any blockages found then reconnect the hose securely.
Squeeze tabs to remover
dial cover.
Removing blockages from the TurboTool
Turn the TurboTool over and slide
off the locking ring.
Replacing the brushbar belt
Unscrew the 4 screws
from the base of the unit
using a crosshead
screwdriver.
vax.co.uk
All manuals and user guides at all-guides.com
(Keep your Vax as good as new)
Pull dial towards you.
Locking ring
Detach lower housing and
remove blockage.
Remove floor nozzle cover. Lift brushbar and remove
Clean and remove any
debris from inside.
(some models only)
To re-assemble the TurboTool, ensure
that the tabs are engaged and pivot the
lower housing closed. Slip the locking
ring over the neck of the TurboTool and
into the groove to finish.
belt from the end of the
brushbar.
Remove lower hose and
check for blockages.
Tabs
9