Using Your Machine; Before You Begin Cleaning; Using Accessories; Attaching The Hose - Vax MachAir UCA1GEV1 Quick Start Manual

Using your machine

Before you begin cleaning

• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat, the
thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug from
the electrical socket. Remove and empty the dirt container and also check the vacuum cleaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully
dry before putting back into the vacuum).
• Pre-motor filters require cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
• When using the accessories always make sure the machine is stood in the upright position.
NOTE: The brushbar will not spin until the machine is reclined.

Using accessories

NOTE: The Turbotool, 2-in-1 Tool and 3-in-1 Tool can all be attached to the tube or directly to the hose.

Attaching the hose

Remove the hose end
from the floorhead.
Extension tube
Remove the
extension tube.
Choose an accessory.
2-in-1 tool converts into:
A = Crevice Tool
B = Dusting Brush
Attach the hose to the
extension tube.
A
B
C
3-in-1 Tool converts into:
A = Crevice Tool
B = Upholstery Tool
C = Dusting Brush
Attach the accessory to the
extension tube.
Attach the accessory
to the hose end.