Soldered Jumpers - Epson S1R72U06 Manual

3. Jumper Settings
3.2

Soldered jumpers

No.
JP11 U06 internal regulator enable switching
JP15 MAX8586 auto restart function selection
(For more information, refer to MAX8586 data
sheet.)
JP2 1.8 V circuit current measurement jumper
JP6 CVDD current measurement jumper
JP7 VRIN current measurement jumper
JP17 VBUS_5V_IN current measurement jumper
JP8 Clock frequency selection
JP9 U06 internal regulator input capacitor (LVDD)
JP10 LVDD external input selection
JP12 U06 internal regulator input capacitor (UVDD3)
JP13 UVDD3 external input selection
122 F capacitor discharge resistance selection for
JP14
USB host VBUS output
JP18 MAX8586 EP-PAD connection selection
(EP) (For more information, refer to MAX8586 data sheet)
Note: JP18 (EP) is not noted in the circuit diagram.
Note: Refer to "10.1 Exterior view diagram" for the soldered jumper layout.
4
Content
EPSON
Setting
1-2 Disable
1-3 Enable
1-2 MAX8586-ENRESET pin = High
1-3 MAX8586-ENRESET pin = Low
Open -
Short Always shorted
Open -
Short Always shorted
Open -
Short Always shorted
Open -
Short Always shorted
Open 24 MHz
Short 12 MHz
Open With LVDD external input
Short When using U06 internal regulator
Open When using U06 internal regulator
Short With LVDD external input
Open With UVDD3 external input
Short When using U06 internal regulator
Open When using U06 internal regulator
Short With UVDD3 external input
Open No discharge resistance
Short With discharge resistance
Open -
Short Connect to GND
S1R72U06 Evaluation Board Manual
(Rev.1.0)