Summary of Contents for Ingersoll-Rand 2902 Series
Page 1
Form 04584231 Edition 1 April 2005 Air Impact Wrench 2902 Series Maintenance Information Save These Instructions...
Page 2
Grease Fitting (37, 32). Use Ingersoll-Rand No. 10 Oil for lubricating the motor. Inject Work approximately 8 cc of Ingersoll-Rand Air Impact Wrench approximately 1 to 2 cc of oil into air inlet (6, 21) before attaching the Grease No.
Page 3
For the 2902SB Remove the Throttle Valve Face (39) from the annular groove at the end of the Throttle Valve. Unscrew and remove the Inlet Bushing (6). NOTICE Lift off the Exhaust Deflector (8) and Deflector Gasket (9). Using an awl, remove the Exhaust Silencer (10) from the handle.
Reverse Valve. Tighten the Stop to 4 to 7 in-lb (.45 to .80 Nm) torque. Frame so they engage the notches on the Hammer. Coat the Anvil (66, 69, 72, and 79) with a light film of Ingersoll-Rand Assembly of the Motor Grease No.105.