Rapid Advance Mode - Dexter Laundry T-300 Operator's Manual

4.3

RAPID ADVANCE MODE

Rapid Advance mode is a key-controlled override to interrupt the current
cycle, drain the water, and advance to the next mode of the wash cycle,
including Pre Wash, Wash, Rinse, Final Rinse, Spin. The indicator lights
will show to which segment the cycle has been advanced.
To enter the Rapid Advance mode, turn the key counter-clockwise (CCW).
The Rapid Advance setting is not marked next to the key, but turning the
key CCW until it stops selects this mode. The Rapid Advance mode can
be entered from either the Idle mode or during the cycle. If the cycle has
not yet started, press the "START" button. To rapid advance to the next
step in the wash cycle, push both the "UP" and "START" buttons at the
same time. The display will show "Ad" (advance) in the display. The
washer will advance to the next bath segment only after the water is
drained from the washer.
Note:
- The time displayed may not be accurate.
- The cycle will continue in rapid advance mode even if the key is
turned to "RUN" and/or removed.
- Rapid advance cannot skip the final 1-minute tumble of the cycle,
and the door lock may remain activated for a couple minutes after
the cycle has been completed.
- The chemical injection signals will NOT operate in Rapid Advance
mode.
To end the cycle without waiting for the time to count down,
press and hold the "STOP" button for 5 seconds or more.
8514-297-001 REV F page 58