Plumbing; Drain; Protective Film; Electrical - Dexter Laundry T-300 Operator's Manual

2.8

PLUMBING

Water supply hoses are provided with each machine. The threaded
connections on the hoses are ¾-11 ½ NHT for 60 Hz models and ¾-14
BSP for 50 Hz models.
Separate hot and cold water lines must be supplied to the machine,
maintaining 30 psi to 120 psi (207 kPa to 827 kPa) water flow pressure. A
140°F (60°C) hot water supply is recommended for best washing results.
Do not exceed 180°F (82°C) water temperature.
2.9

DRAIN

The drain outlet tube size:
For T-300 and 350 is 2 ¼ inches (57 mm) in diameter,
and for all other models is 3 inches (76 mm) in diameter.
Any drain hose used must be lower than the drain valve to assure proper
draining.
2.10

PROTECTIVE FILM

The machine may have protective adhesive film on the front control panel
label area and on the front, top, and side stainless steel panels. The film
may be peeled off before putting the machine into service.
2.11

ELECTRICAL

The Dexter single/three-phase 208-240VAC 60 Hz (single phase 230VAC
50 Hz) washing machines are intended to be permanently installed
appliances. No power cord is provided. The machine should be
connected to an individual branch circuit not shared by lighting or other
equipment. The connection should be sheathed in liquid-tight or
approved flexible conduit, or equivalent, with conductors of the proper
size and insulation (50 Hz: A means for disconnection with a contact
separation of at least 3 mm must be provided. The sheath of the supply
cord must be at least equivalent to that of a cord complying with IEC 227
or IEC 245). A qualified technician should make such connections in
accordance with the wiring diagram. See specification sheet for minimum
recommended wire size.
Individual circuit breakers for each unit are required. Do not use ground-
fault (earth-fault) circuit breakers or ground-fault (earth-fault) circuit
interrupter outlets.
8514-297-001 REV F page 43