General Specifications - Pro-face ST3000 Series Hardware Manual

ST3000 Series Hardware Manual
3.1 ST-3200 Series
3.1.1

General Specifications

Electrical Specifications
Input Voltage
Rated Voltage
Allowable Voltage Drop
Power Consumption
In-Rush Current
Voltage Endurance
Insulation Resistance
*1. The FWHM (Full-width, half maximum) value is approximately 40µs. (When exceeding
Environmental Specifications
Surrounding Air
Temperature
Storage Temperature
Ambient Humidity
Storage Humidity
Dust
Pollution Degree
Atmosphere
Air Pressure Vibration
Resistance (availment
altitude)
Vibration Resistance
Concussion Resistance
Noise Immunity
Electrostatic Discharge
Immunity
*1. Extended use in environments where surrounding air temperature is 40°C or higher may
3-2
30A)
degrade the display quality and result in decreased contrast.
DC19.2 to 28.8V
2ms (max.)
13W (max.)
60A (max.)
AC1000V 20mA for 1 minute
(between charging and FG terminals)
DC500V 10MΩ (min.)
(between charging and FG terminals)
0 to +50°C
-20 to +60°C
10 to 90% RH
(Wet bulb temperature: 39°C max. - no condensation.)
10 to 90% RH
(Wet bulb temperature: 39°C max. - no condensation.)
3
0.1mg/m and below (non-conductive levels)
For use in Pollution Degree 2 environment.
Free of corrosive gases
800 to 1114hPa
(2,000 meters above sea-level and below)
IEC61131-2 compliant
5 to 9Hz single-amplitude 3.5mm
9 to 150Hz constant-accelerated velocity 9.8m/s
X,Y,Z directions for 10 cycle (100 minute)
IEC61131-2 compliant
2
(147m/s X,Y,Z directions for 3 time)
Noise Voltage: 1000V
Pulse Duration: 1µs
Rise Time: 1ns
(via noise simulator)
6kV (complies with EN 61000-4-2 Level 3)
DC24V
*1
*1
P-P
2