ring Contact Sensor Manual page 3

Installation
1. Choose a door or window for installing your Contact Sensor and companion magnet.
2. Ensure the surfaces where you plan to install your sensor and magnet are clean and free from dust or dirt.
3. Using the provided double-sided tape, peel the backing and attach the sensor to the mounting location.
4. Follow the same steps for the companion magnet ensuring the magnet is aligned with the sensor and no more than 1 inch
from sensor for the "closed" position.
Note: Leave ~ ½ in. of space on the side opposite the magnet to ensure you can slide open the case when it's time to change the
batteries.
Note:
•
This product can be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers. All mains
operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
•
This is a SmartStart enabled product which can be added into a Z-Wave network by scanning the Z-Wave QR Code present
on the product with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will be
added automatically within 10 minutes of being switched on in the network vicinity. This product can also be operated in any
Z-Wave network with other Z-Wave certified devices from other manufacturers.
Z-Wave Instructions
Z-Wave Device Type: Notification Sensor
Role Type: Reporting Sleeping Slave (RSS)
•
GENERIC_TYPE_SENSOR_NOTIFICATION (0x07)
•
SPECIFIC_TYPE_NOTIFICATION_SENSOR (0x01)
Ring Alarm Contact Sensor Inclusion
Adding Ring Alarm Contact Sensor to a Z-Wave Network
Ring Alarm Contact Sensor can be added via SmartStart or Classic inclusion mode.
Date:
Ring Alarm Contact Sensor User Manual
Version: 0.1 Page: - 3 -