Table of Contents
Advertisement
C
I
OMPLETING THE
NSTALLATION
Fixing the Indoor Unit in Place
Perform the following work on the area where gas leak test was done priorly.
<Figure A>
Insulation
Pipes
Installation plate
Vinyl tape
Connecting wires
Drain hose
16
E-
After checking for gas leaks in the system, insulate the pipe, hose and cables.
Then place the indoor unit on the installation plate.
1
To avoid condensation problems, wrap foam insulation (as shown in the figure
A) on a part without insulation on the end of the pipes.
2
Wind the pipe, assembly cable and drain hose with vinyl tape.
3
Place the bundle (the pipe, assembly cable and drain hose) in the lower part of
the indoor unit carefully so it does not project from the rear of the indoor unit.
4
Hook the indoor unit to the installation plate and move the unit to the right
and left until it is securely in place.
CAUTION Make sure pipe does not move when you install the indoor unit
Connecting
5
Wrap the rest of the pipe with vinyl tape.
pipes
6
Attach the pipe to the wall using clamps (optional).
on an installation plate.
Advertisement
Table of Contents
