Makita DUH604S Instruction Manual page 9

To reverse the shear blades movement, press the
reverse button when the shear blades have stopped,
then pull the front switch trigger, and then pull the rear
switch trigger while pressing the lever. The power lamp
starts blinking, and the shear blades move in reverse
direction.
When entangled branches and debris are removed,
the tool returns to the regular movement and the power
lamp stops blinking and lights up.
► 1 . Power lamp 2. Reverse button
NOTE: If the entangled branches or debris cannot be
removed, release the switch triggers, then press the
reverse button, and then pull the switch triggers until
they are removed.
NOTE: If you tap the reverse button while the shear
blades are still moving, the tool comes to stop and to
be ready for reverse movement.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When replacing the shear blades,
always wear gloves so that your hands do not
directly contact the blades.
NOTICE:
When replacing the shear blades, do
not wipe off grease from the gear and crank.
Installing or removing the shear
blades
CAUTION:
Attach the blade cover before
removing or installing the shear blades.
You can install 600 mm or 750 mm shear blades to your
tool.
NOTE: If you change the shear blades to a different
length, replace the chip receiver with one which fits
the blades.
1. Remove 4 screws (for DUH604S) or 5 screws (for
DUH754S), and then remove the chip receiver from the
tool.
1
2
► 1 . Chip receiver 2. Screw
2. Place the tool upside down, and then remove 6
bolts.
1
► 1 . Bolt
3. Remove the cover and the plate.
► 1 . Cover 2. Plate
NOTE: The plate may remain on the cover.
9 ENGLISH
1
2
1
2