Makita DUH604S Instruction Manual page 11

10. Insert the protrusion on the shear blades to the
hole on the rod, then align the position of the felt pad
with the holes on the tool. Attach 2 new sleeves and 2
washers.
1
3
4
5
► 1 . Felt pad 2. Protrusion 3. Hole 4. Washer
5. Sleeve
NOTICE:
Apply a small amount of grease to the
inner periphery of the hole of the rod.
NOTICE:
Be careful not to lose the washers and
the sleeves.
11. Align the holes on the washers, sleeves, and
shear blades with the holes on the tool, and then tighten
2 screws to temporarily fix the shear blades.
1
► 1 . Screw
12. Attach a new sleeve.
2
► 1 . Sleeve
13. Remove the screw and the washer inserted into
the hole on the shear blades in step 9, and then tighten
the screw together with the sleeve and the washer to fix
the shear blades.
► 1 . Screw and washer
14. Firmly tighten the screws which were temporarily
fixed in step 11.
15. Attach the bearing and the rod.
► 1 . Rod 2. Small hole 3. Bearing
11 ENGLISH
1
1
2
3
NOTICE:
Apply a small amount of grease to the
inner periphery of the small hole of the rod.
NOTICE:
Make sure that the protrusion on the
shear blades fits in the small hole on the rod.
1