Advertisement
3-10
Grasp agitator firmly and fit it into
position by first sliding the end opposite
the belt into the rectangular slot (F) on
side of cleaner.
Pull other side of agitator (G) into place.
Turn agitator, making sure belt is not
pinched between agitator and agitator
shield.
When to replace the
agitator brush roll
When agitator brushes are worn,
the agitator should be replaced.
To check condition of brushes,
disconnect cleaner from
electrical outlet.
Move the edge of a card across
bottom plate while turning agitator.
To maintain cleaning effectiveness,
replace agitator if brushes do not
touch card.
Cleaning Clogs
Low suction or poor pickup may be
due to a clog in the vacuum
cleaner. If you notice a change in
the sound of the motor or a
reduction in the spinning action,
check for clogs.
3-15
M a i n t e n a n c e
3-11
Reposition bottom plate and 4
screws. Tighten screws securely.
3-12
3-13
Empty Dirt Container.
Check Upper Tank for build up or
clogs.
Grasp the Quick Reach Handle
and lift Hose Wand to
separate from the suction opening.
Check for a clog in
the Base, the Wand or the Hose.
Remove the screw attaching the
Hose Wand Base to the
vacuum. Straighten the Hose
Wand Base and unclog
with long, narrow object.
6
How to replace
Disconnect cleaner from electrical
outlet.
Remove bottom plate, belt and
agitator following directions in "The
belt" section beginning with Fig. 3-10.
Discard old agitator.
Continue following the directions in
"The belt" section to reposition belt,
new agitator and bottom plate.
3-14
Remove the Upper Tank and check
the suction inlet for a clog.
WARNING:
To reduce the risk of injury from
moving parts and/ or electrical
shock, turn Power Switch OFF and
disconnect plug from electrical
outlet before performing
troubleshooting checks.
3-16
Air Passageway
If the clog persists, follow the
instructions for Checking
the Rotating Floor Brush on page 9
and inspect the Air
Passageway for obstructions.
Suction Inlet
Advertisement
