Advertisement
2-6
Cleaning lightweight flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle(front of
cleaner)and will prevent rug from clinging
to cleaner.
Continue to lift front of cleaner so that
when you have reached the edge, it is
completely off the rug. Move cleaner
back to start again, lower front of cleaner,
and use only forward strokes.
3. How to maintain youer samsung vacuum
Empty Dirt Container
The Dirt Container needs to be
emptied when the dirt reaches
the "Full" line on the side of the
Container.
3-1
Unlock
Position
① Unplug the cleaner from electrical
outlet.
② Slide the Lock 'n Seal Lever to
the "Unlock" position.
③ Grasp handle and pull the Dirt
Container straight out to remove
from vacuum.
④ Empty dirt into garbage
container.
⑤ Put the Dirt Container back in the
vacuum and slide the lever to the
"Lock" position.
M a i n t e n a n c e
2-7
2-8
2-9
Cleaning The Upper Tank & Filter
3-2
Full Line
Lock Position
3-3
Note: The Dirt Container may
be washed in warm water
with a mild detergent. Make
sure it is completely dry
before using again.
Carpet height adjustment
Carpet and rug cleaning takes place at the
nozzle (A).
When it is necessary to raise and lower the
nozzle for various carpet pile heights, rotate
the nozzle control knob (B) to the desired
setting.
For maximum cleaning performance, The
following carpet height settings are recommended:
·Lowest setting: for all types of carpet
·Higher settings: for very deep pile carpet where
easier pushing effort is desired, while maintaining
good cleaning performance.
Note: If the cleaner is difficult to push, rotate knob to
the next higher setting.
Power control (some models only)
To change the power level of the vacuum
cleaner, rotate the knob.
① Unplug the cleaner from electrical
outlet.
② The Upper Tank Filter can be
reached by removing the Dirt
Container, reaching underneath the
Upper Tank and turning the rim of
the Filter Frame to unlock. Pull
straight down to remove. Brush the
dirt off the Louvers and Upper Tank
Filter.
③ The foam Upper Tank Filter may be
removed and hand washed in cold
water with mild detergent. Rinse
well then air dry thoroughly before
replacing.
④ The Upper Tank and Louvers may
also be wiped clean with a damp
cloth.
4
Advertisement
