Operation - Makita CRU03 Instruction Manual

Installing the protector
WARNING:
Never use the tool without the guard illus-
trated in place. Failure to do so can cause serious personal injury.
CAUTION:
Take care not to injure yourself on
the cutter for cutting the nylon cord.
Attach the protector to the clamp using bolts.
2
► 1. Clamp 2. Protector 3. Cutter
Installing the cutting tool
CAUTION:
Always use the supplied
wrench(es) to remove or to install the cutting tool.
CAUTION:
Be sure to remove the hex wrench
inserted into the tool head after installing the cutting tool.
NOTE: The type of the cutting tool(s) supplied as the
standard accessory varies depending on the countries.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
Nylon cutting head
NOTICE:
Be sure to use genuine Makita nylon
cutting head.
4
5
2
► 1. Nylon cutting head 2. Spindle 3. Hex wrench
4. Loosen 5. Tighten
1. Insert the hex wrench through the hole in the gear case to lock
the spindle. Rotate the spindle until the hex wrench is fully inserted.
1
3
1
3
2. Place the nylon cutting head onto the spindle and
tighten it securely by hand.
3.
Remove the hex wrench from the gear case.
To remove the nylon cutting head, follow the installation
procedures in reverse.

OPERATION

Adjusting the working position
CAUTION:
Before performing this procedure,
install the battery cartridge(s) to the portable
power pack and finish the adjustments for the
waist belt and shoulder harness. Refer to the
instruction manual of the portable power pack for
detail.
CAUTION:
To prevent unintentional start up,
never turn on the portable power pack throughout
this procedure. The battery cartridge(s) is to be
installed only to obtain the usability with actual weight
balance.
1. Pull out the cord from the right side of the portable
power pack. When pulling out the cord, be sure to set
the cord in the holders as shown in the figure.
► 1. Cord 2. Holder
2. Wear the shoulder harness of the portable power
pack and lock the buckle on the waist belt.
11 ENGLISH
1
2