Table of Contents
Advertisement
Operation Instructions:
1. Switch the power on, there will be a beep and the power indicator "G" lights up.
The system now is in standby mode.
2. Switch on the water heater by pressing "
outlet water temperature.
3. The user can set the desired temperature by touching the control button "+", "-". Press the "+" or "—"button
each time,the temperature will increase or decrease 1
4. Press button"..."can shift display mode among water flow & the setting temperature of outlet water.
5. In some cases, if ambient temperature is low, adjust water flow rate down, to get higher temperature.
Note:
A.
Do not wet w ater heater.
B.
If hot water system is installed inside shower be careful to avoid Scalding, after frequent usage.
C.
Power off: After use, press "
valve/mixer.
D.
If this heater will not be used for a long period of time, disconnect the main power( air -break switch
or RCCB). If the unit is to be left unused for an extended period of time in a cold region, drain
the water inside it to avoid continuous cold water.
Water Temperature Regulation
The GL5 series highest outlet water temperature can up to
temperature should not be set higher than 45℃.
". The display screen will display the setting temperature & actual
℃ .
" to switch off the water heater FIRST, then turn off the water inlet
o
50C。 When you are showering, the
8
Advertisement
Table of Contents
