Download Print this page

Gleamous DSL-30N Instruction Manual

Storage water heater over-sink

Advertisement

Quick Links

Page:
Thank you for your choice of our products.
To enjoy the service of this unit, Please read this manual carefully and follow the
instruction rules.
1.
The unit shall only be installed and maintained by authorized and qualified person. We urge you to
read all of instructions thoroughly before installation or operation. The manufacturer will not be liable
for any damages caused by failure installation and operating.
2.
Warning: The unit must be properly grounded.
3.
Before switch on the power, make sure that all pipeline are connected, the unit is full filled with water
and water drips from the water outlet.
4.
If the unit is found abnormal during operation, immediately shut off the power supply and contact the
manufacturer or your dealer for service.
5.
The unit shall not be installed in a place subject to freezing.
6.
The exposed parts and conectiong pipes of the unit are hot. Keep your children from touching them
so as to avoid risks.
7.
The highest temperature is up to 95℃, don't touch the hot water to prevent scalding.
8.
The water heater is not intended by the body, sensory or mental impairment, or lack of experience
and knowledge of the people(including children) use. Unless the person responsible for their safety
use of water in supervision and guidance.
9.
Don't allow the children play the unit.
please read carefully and preserve the Instruction manual.

Instruction Manual

Storage Water Heater
Over-sink Water Heater
For proper operation and maintenance

Advertisement

loading

Summary of Contents for Gleamous DSL-30N

  • Page 1: Instruction Manual

    Instruction Manual Storage Water Heater Over-sink Water Heater For proper operation and maintenance please read carefully and preserve the Instruction manual. Page: Thank you for your choice of our products. To enjoy the service of this unit, Please read this manual carefully and follow the instruction rules.
  • Page 2 The product uses separate 240V~, 50Hz power supply. The water heater shall be properly grounded. The earth wire and zero line shall be strictly isolated. Never connect the zero line of the socket to the earth wire as this may case accident. After installation, it is important to fill the unit with water before switch on the power so as to prevent it from dry-burning and damage.
  • Page 3 The electric water heater shall be installed on wall, vertical, outlet & inlet towards down. First determine the installation position of the heater required and then make two holes in the wall with a churn drill with reference to the mounting holes as shown in Fig. I. Drive anchor bolts into the holes with a hammer.
  • Page 4 Switch on the unit, the buzzer sounds ”B1”, the unit is in standby mode. Press the ON/ OF botton, the screen will light and the unit starts heating; press the button once again to stop heating. Press Temperature Setting button to set heating temperature from 35℃ to 95℃. Press the button each time, the temperature will be with 5℃...
  • Page 5: Specifications

    IV. Specifications Model Rated Rated Recommended Rated Rated Dimension Number Voltage Power Breaker Capacity Pressure DSL-30N 240V 25/32Amps 0KPa 441*250*162mm...
  • Page 6 Clean the water heater and Venturi tube with a soft cloth. Never wipe it with detergent. The entire water heater, electric connection and water connection shall be inspected by qualified service personnel at least once per two years. In this way the safe operation and use of the unit can be ensured.