Operation; Assembling Your Carpet Washer - Hoover Power Scrub Elite User Manual

OPERATION

3
PLEASE READ 'GENERAL SAFETY INFORMATION' AT THE BEGINNING BEFORE USE
IMPORTANT: Carpets should be dry vacuumed thoroughly before washing.
Test for colourfastness – Wet a white absorbent cloth with the solution. In a small hidden area of your
carpet/rugs/upholstery gently rub with the dampened cloth. Wait ten minutes and check for colour
removal or bleed with a white paper towel or cloth. If your carpet has more than one colour, check
all colours.
Test your carpet/rugs/upholstery – Run the carpet washer over a small hidden area. If no pile
distortion occurs continue cleaning.
When cleaning an entire room, move furniture out of the area to be cleaned. If the furniture cannot
be moved, place aluminium foil or wax paper under the legs. This will prevent wood finishes from
staining your carpet. Pin up furniture skirts and curtains.
When using the carpet washer, basic safety precautions should always be observed and don't over
saturate your carpets. Only use Hoover carpet solution. Using other solutions may cause excess
foaming and will invalidate your guarantee. The clean water tank should only be filled with warm
water (max 40°C). Filling the clean water tank with hot/boiling water will damage your machine
and invalidate the guarantee. This is a powerful carpet washer, before plugging in make sure all
controls are turned off. Hold carpet washer firmly when starting and during use.

Assembling your Carpet Washer

Line up the handle
and slide onto the
main body.
Insert the 2 screws and
tighten using a cross
head screwdriver.
Tilt the clean water/
solution tank and line
up onto the carpet
washer. Push the tank
back until it clicks into
place.
Wrap the power cord
around the cord hooks
for storage.