Removing And Cleaning The Nozzle - Hoover Power Scrub Elite User Manual

MAINTENANCE
9
Lift and hook the latch
on the tank onto the lid
and push down to lock
into place.

Removing and cleaning the nozzle

Remove both tanks
and tilt the carpet
washer so it is lying on
its back.
To replace the nozzle, hook the tabs on the
nozzle with the front of the carpet washer
and slide the nozzle into place.
NOTE: To prevent excessive build up of dirt/
debris in the nozzle, always dry vacuum before
using the carpet washer.
To re-fit, slide the dirty
water tank onto the
carpet washer, making
sure the tabs on the
tank line up with the
back of the washer.
Lift the nozzle release
clip to unlock the
nozzle.
Hook the tank release
catch over the front
of the tank and push
downwards to lock the
catch in place.
Hold the front of the
nozzle and push down
to release the nozzle
away from the washer.
Once released, lift to
remove.
Push the nozzle
release clip to lock
the nozzle.
Rinse the nozzle under
water (40°C max) to
remove dirt and debris.