Installing Planmeca Ethernet Interface - Planmeca Ethernet Interface Installation Manual

INSTALLATION OF THE PLANMECA ETHERNET INTERFACE BOX TO THE DIXI3 DIGITAL INTRA X-RAY

2.2 Installing Planmeca Ethernet Interface

To install the Planmeca Ethernet Interface first attach the Ethernet interface box to the power
supply and plug the power supply to the mains. Check that the OK indicator light on the Plan-
meca Ethernet Interface box comes on (see picture below).
Attach the RJ45 Cat. 5 UTP cable from 10/100 Base-T directly to the hub or the cross-con-
nected Cat. 5 UTP cable to the computer. The Link light comes on on the Planmeca Ethernet
Interface.
Attach the 15m interconnection cable from Dixi3 either to Port 1 or Port 2 (or to both of them
in case you use two Dixi2 systems). Check also that the PWR (power) light comes on.
Installation manual
10/100 Base-T PLANET
LINK
TX/RX
Link
10/100 Base-T PLANET
LINK
TX/RX
3-metre RJ45 cable
OK indicator light
PORT 1 PORT 2
PWR
OK
STATUS
PLANMECA ETHERNET INTERFACE
PORT 1 PORT 2
PWR
OK
STATUS
PLANMECA ETHERNET INTERFACE
PWR
Power supply
cable
13,2VDC IN
max. 1A
SET
13,2VDC IN
max. 1A
SET
Planmeca Ethernet interface 3