Connecting The Cables; Care And Cleaning - Teufel VT 11 Technical Description And Operating Instructions

Connecting the cables

Danger Danger of injury/damage!
Arrange the cables so that they do not pose a
trip hazard.
1. Turn off your amplifier.
2. Lay the speaker cables from your amplifier to each
speaker. These cables should be high-quality double-
wire speaker cable with marked strands.
A connector terminal with two terminal clips is located
on the back side of each speaker. Here you can con-
nect the speaker cables directly or with pin plugs. We
only describe the direct connection in these instruc-
tions.
The terminals are each marked in red (+) and black (-).
Make sure the polarity is correct!
Connect the same-colour terminals of your
speakers and amplifier with each other. Oth-
erwise the sound quality will suffer. The individual single
wires of the speaker cables are marked with different
colours or shapes to facilitate the process.

Care and cleaning

The veneered surfaces of our speakers have a protective
surface coat, which eliminates the need for wood polish.
• You can best remove dust or small amounts of dirt with
a dry, smooth leather cloth.
• Rub off stubborn dirt with a damp cloth. Make sure
that no liquids penetrate the speakers.
• Then immediately wipe the surfaces dry using a soft
cloth and without applying pressure.
6
• VT 11
3. Split the single wire on both ends up to approx. 30 mm
and remove approx. 10 mm of the insulation on each
single wire. Twist the stripped single wire ends together
so that no wire protrudes.
4. Push the grooved lever on the spring clip terminal and
insert the stripped end of the wire into the hole that
appears. Let go of the lever.
The speaker cable has now been clamped in place.
5. Connect the speaker cables to your amplifier. The
operating instructions of the appliance should contain
notes on this.
Attention Risk of damage!
Using the wrong cleaning materials may dam-
age the delicate surface of the case.
• If possible only use lukewarm, plain water without any
cleaning products. In case of stubborn marks, a mild
soap solution may be used.
• In no circumstances should caustic cleaning products,
white spirit, thinners, petrol or similar be used for
cleaning.