Connecting The Cables - Teufel DEFINION 3 Technical Description And Instruction Manual

Connecting

Connecting the cables

1. Turn off your amplifier/AV receiver.
2. Lay the speaker cables from your amplifier/AV
receiver to each speaker.
The two connector terminals are located on the
back side of the speaker.
The terminals are marked in red (+) and black (-).
NOTICE
Wrong polarity will result in loss of sound
quality!
– Connect the like-coloured clamps of the
amplifier and speaker with each other.
One speaker cable strand has been
marked.
3. If you use a speaker cable with pin plugs from our
product range, simply insert the pin plugs in the
terminal connectors.
4. If you insert cables with loose ends, split the
wire down to approx. 30 mm on both ends and
remove approx. 10 mm of the insulation on each
end. Twist the single wire so that no strands are
protruding.
5. Turn the connector terminal counter-clockwise
until loose. Run the stripped cable end into the
now visible hole. Close the terminal by turning
it counter-clockwise. The cable has now been
clamped in place.
Cable lugs are clamped in place in the same
manner. However, they are not inserted into the
hole of the connector terminal.
6. Turn your amplifier/AV receiver back on.
6 • HiFi column speakers DEFINION 3