Maintenance; Residual Risks; Risk Reduction - Ryobi RCP1225 Original Instructions Manual

MAINTENANCE

WARNING
Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, poor performance and may
void your warranty.
WARNING
Before inspecting, cleaning or servicing the
product, unplug the power cord and wait for
all moving parts to stop. Failure to follow
these instructions can result in serious
personal injury or property damage.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to damage
from various types of commercial solvents
and may be damaged by their use. Use clean
cloths to remove dirt, dust, oil, grease, etc.
WARNING
Do not at any time let brake fl uids, gasoline,
petroleum-based products, penetrating oils,
etc., come in contact with plastic parts.
They contain chemicals that can damage,
weaken or destroy plastic.
WARNING
The tines are sharp. Use caution and wear
heavy duty gloves when fi tting, replacing,
cleaning or checking bolt security.
■
After each use, clean the body and handles
of the product with a soft dry cloth, and
clean the debris from the tines with a stiff
brush.
■
Check all nuts, bolts and screws at frequent
intervals for proper tightness to ensure the
product is in safe working condition.
■
Only the parts shown on the replacement
part list are intended to be repaired or
replaced by the customer. All other parts
should be replaced at an authorised
service centre.

RESIDUAL RISKS

Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
4 | English
manufacturer's
accessories and
hazards may arise during use and the
operator should pay special attention to avoid
the following:
■
Contact with tines.
■
Injury caused by vibration. Hold the product
by designated handles and restrict working
time and exposure.
■
Exposure to noise can cause hearing injury.
Wear ear protection and limit exposure.
■
Eye injury due to flying debris. Wear eye
protection at all times.

RISK REDUCTION

It has been reported that vibrations from
hand-held products may contribute to a
condition called Raynaud's Syndrome in
certain individuals. Symptoms may include
tingling, numbness and blanching of the
fi ngers, usually apparent upon exposure to
cold. Hereditary factors, exposure to cold
and dampness, diet, smoking and work
practices are all thought to contribute to the
development of these symptoms. There are
measures that can be taken by the operator to
possibly reduce the effects of vibration:
■
Keep your body warm in cold weather.
When operating the product wear gloves
to keep the hands and wrists warm. It is
reported that cold weather is a major factor
contributing to Raynaud's Syndrome.
■
After each period of operation, exercise to
increase blood circulation.
■
Take frequent work breaks. Limit the
amount of exposure per day.
If you experience any of the symptoms of this
condition, immediately discontinue use and
see your doctor about these symptoms.
WARNING
Injuries may be caused, or aggravated, by
prolonged use of a tool. When using any
tool for prolonged periods, ensure you take
regular breaks.
KNOW YOUR PRODUCT
See page 151.
1. Handle
2. On/off switch
3. On/off switch lock
4. Power cord
5. Motor control cable