Synchronising The Remote To Receiver; Troubleshoot - TEUCER LR-RGB/RGBW Quick Start Manual

1 zone rf controller and receiver for rgbw led strip
Table of Contents

Advertisement

CONTROLLER AND RECEIVER
LR-RGB/RGBW and R4C
1 zone RF controller and receiver for RGBW LED strip

Synchronising the remote to receiver

1) Ensure the receiver has power. Press the match button on the receiver. Indicator will start flashing.
Match bu�on
2) Press any button on the remote to allocate the receiver within 5 seconds after pressing the match button.
The indicator will stop flashing, and the controller will be synchronised.
Press any bu�on to
allocate
the receiver

Troubleshoot

Problem
No light
Wrong Colour
Uneven intensity be-
tween front and rear of
the strip, with voltage
drop
No response
from the remote
R4C
3) To restore to factory default settings and delete the allocated con-
troller, press and hold the match button longer than 5 seconds.
Cause
No power.
Wrong connection or unsecure connec-
tion.
Wrong connection of RGBW wires.
Output cable is too long.
Cable diameter is too small.
Overload beyond driver capability.
Overload beyond receiver capability.
The battery has no power.
Beyond controllable distance.
The controller isn't synchronised with the
remote.
Brighter for longer
Corrective
Check the power.
Check the connection.
Re trace and reconnect
RGBW wires.
Reduce cable or loop supply.
Change to a thicker cable.
Replace with a suitable high-
er power driver.
Add a power repeater.
Replace battery.
Reduce remote to receiver
distance.
Re-sync the remote.
www.teucerled.co.uk

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LR-RGB/RGBW and is the answer not in the manual?

This manual is also suitable for:

R4c

Table of Contents