Synthetic Compressor Lubricant Material; Compatibility List; General Requirements; Condensate Discharge Piping - Ingersoll-Rand SS3 Owner’s Manual With Parts Lists

SYNTHETIC COMPRESSOR LUBRICANT MATERIAL COMPATIBILITY LIST
„
SUITABLE
• Viton®
• Teflon®
• Epoxy (Glass Filled)
• Oil Resistant Alkyd
• Fluorosilicone
• Fluorocarbon
• Polysulfide
• 2-Component Urethane
• Nylon
• Delrin®
• Celcon®
• High Nitrile Rubber (Buna N. NBR more than 36%
Acrylonitrile)
• Polyurethane
• Polyethylene
• Epichlorohydrin
• Polyacrylate
• Melamine
• Polypropylene
• Baked Phenolics
• Epoxy
• Modified Alkyds (® indicates trademark of DuPont
Corporation).

GENERAL REQUIREMENTS

„
The piping, fittings, air receiver tank, etc. must be certified
safe for at least the maximum working pressure of the unit.
Use hard-welded or threaded steel or copper pipes and cast
iron fittings and hoses that are certified safe for the unit's
discharge pressure and temperature. DO NOT USE PVC
PLASTIC Use pipe thread sealant on all threads, and make up
joints tightly to prevent air leaks.

CONDENSATE DISCHARGE PIPING

„
If installing a condensate discharge line, the piping must be at
least one size larger than the connection, as short and direct
as possible, secured tightly and routed to a suitable drain
point or waste container. Condensate must be disposed of in
accordance with local, state, and federal laws and regulations.
All compressed air systems generate condensate which
accumulates in any drain point (eg tanks, filters, drip
legs, after-coolers, dryers) This condensate contains
lubricating oil and/or substances which may be
regulated and must be disposed of in accordance with
local, state, and federal laws and regulations
22204911 Rev. E
RELEASED 13/Feb/2019 14:38:46 GMT
INSTALLATION
NOTICE
NOT RECOMMENDED
• Neoprene
• Natural Rubber
• SBR Rubber
• Acrylic Paint
• Lacquer
• Varnish
• Polystyrene
• PVC
• ABS
• Polycarbonate
• Cellulose Acetate
• Low Nitrile Rubber (Buna N. NBR less than 36%
Acrylonitrile)
• EPDM
• Ethylene Vinyl Acetate
• Latex
• EPR
• Acrylics
• Phenoxy
• Polysulfones
• Styrene Acrylonitrile (San)
• Butyl.
„ COMPRESSOR LUBRICATION
Do not operate without lubricant or with inadequate
lubricant Ingersoll Rand is not responsible for
compressor failure caused by inadequate lubrication

SYNTHETIC COMPRESSOR LUBRICANT

„
Ingersoll Rand recommends All Season Select synthetic
lubricant from start-up. See the WARRANTY section for
extended warranty information.

ALTERNATE LUBRICANTS

„
You may use XL-300 or a comparable petroleum-based
lubricant that is premium quality, does not contain
detergents, contains only anti-rust, anti-oxidation, and anti-
foam agents as additives, has a flashpoint of 440°F (227°C)
or higher, and has an auto-ignition point of 650°F (343°C) or
higher
See the petroleum lubricant viscosity table below. The table
is intended as a general guide only. Heavy duty operating
conditions require heavier viscosities. Refer specific operating
conditions to Ingersoll Rand for recommendations.
CAUTION
EN
EN-7