Gasoline Engine Compressors; Connection Procedures - Ingersoll-Rand SS3 Owner’s Manual With Parts Lists

EN
Temperature
Viscosity @ 100°F
Around
Compressor
°F °C SUS
< 40 < 4.4 150
40-80 4.4-26.7 500
80-125 26.7-51.0 750
If you use a petroleum-based compressor lubricant at start-
up and decide to convert to All Season Select later on, the
pump must be decarbonized and flushed before conversion.
Contact Ingersoll Rand for more information.

GASOLINE ENGINE COMPRESSORS

„
If you will be making connections to a remote battery,
the engine on the compressor must be equipped with
an alternator
BATTERY A 12 volt battery with a minimum current rating of
275 CCA (cold cranking amps) and minimum ampere-hour
rating of 24 Ah should be sufficient for cranking most electric
start engines.
BATTERY CABLES Refer to the following table for size and
length recommendations.
Cable Size (GA)
6
4
2

CONNECTION PROCEDURES:

„
1. Connect the battery positive (+) cable (A) to the starter
solenoid terminal (B).
EN-8
RELEASED 13/Feb/2019 14:38:46 GMT
INSTALLATION
Viscosity
(378°C) Grade
Centistokes ISO
32 32
110 100
165 150
NOTICE
Maximum Length
5' (1.5 m.)
7'-2.5" (2.1 m.)
12' (3.6 m.)
SAE
10
30
40
Kohler Engine Battery (+) Positive cable connection point
D
Honda Engine Battery (+) Positive cable connection point
NOTE: Circuit Fuse location at (D). Electric Start will not work
if Fuse is blown. Unit can be rope started, however will not
charge battery if Fuse is blown.
B
D
B
22204911 Rev. E