Advertisement
Output:0 packets, 0 bytes
Configuring a combo interface
To configure a combo interface:
Step
1.
Enter system view
2.
Enter view of the SFP port or RJ-45
port of the combo interface
3.
Activate the RJ-45 Ethernet port or
SFP port
Displaying transceiver module information and
alarming information
Introduction to transceiver modules
Table 18 Commonly used transceiver modules
Transceiver module
type
SFP (Small Form-factor
Pluggable)
XFP (10 Gigabit Small
Form Factor Pluggable)
SFP+
Displaying transceiver module information
To identify transceiver modules, you can use the following command to view the key parameters of the
transceiver modules, including transceiver module type, connector type, central wavelength of the laser
sent, transmission distance, and vendor name or name of the vendor who customizes the transceiver
modules.
0 crc, 0 align errors, 0 overruns
0 dribbles, 0 drops
0 broadcasts, 0 multicasts, 0 pauses
0 errors, 0 underruns, 0 collisions
0 deferred, 0 lost carriers
Command
system-view
interface interface-type
interface-number
combo enable { copper |
fiber }
Application scenarios
Generally used for 100/1000
Mbps Ethernet ports or POS
155M/622M/2.5G ports
Generally used for 10 Gbps
Ethernet ports
Generally used for 10 Gbps
Ethernet ports
Remarks
N/A
N/A
Required
By default, the Ethernet port is active.
Whether can be an
optical transceiver
Yes
Yes
Yes
56
Whether can be
an electrical
transceiver
Yes
No
No
Advertisement
