Advertisement
2.
The other end of the cable provides eight RJ-45 connectors. Connect them to the RJ-45 interface on
the remote device as needed.
Figure 33 Connecting an 8T1 cable
Connecting a CE3/CT3 cable
CE3/CT3 cable overview
You can use a CE3/CT3 interface cable to connect the MIM- 1 CE3 and MIM- 1 CT3 modules.
Figure 34 E3/T3 cable
CAUTION:
HP recommends that you install a special lightning protector at the input end of the E3/T3 cables to protect
them against lightning strikes more efficiently when they are routed outdoors.
Connecting a CE3/CT3 cable
1.
Connect the SMB connector of an E3/T3 cable to the Tx port on the interface module and the other
end to the Rx port on the device to be connected.
2.
Connect the SMB connector of another E3/T3 cable to the Rx port of interface module and the
other end to the Tx port on the device to be connected
28
Advertisement
