Installation Checklist - Sub-Zero 315W Installation Manual

Model 315W Installation
Overlay Panel Installation
The model 315W glass door is made with a sealed,
double-wall tempered glass core. The drill must not
contact this core when drilling. Be sure the hole is
centered on the small groove in the front of the door
frame and the drill passes squarely through the frame.
If you are inexperienced with drilling, fasten the handle
from the rear of the door panel only.
IMPORTANT NOTE: Install screws in all the mounting
holes in the door frame. The nature of the door panel with
a narrow outer rim and no connecting center member
requires the support provided by the glass door.
After the door panel installation is complete, apply the
cover patches or plugs provided over the holes on the
inside surface of the door.
The cover patches or plugs are part of the insulation
system on the door of the wine storage unit. Be sure to
cover all the holes in the door that were used.

Installation Checklist

To ensure a safe and proper installation, the following
checklist should be completed by the installer to ensure
that no part of the installation has been overlooked.
Has all packing material been removed?
Turn the unit on. Is it operating properly? If not, is the
unit plugged in? Is the control turned on?
Has the unit been secured in place with the anti-tip
bracket?
Is the unit level? Are all leveling legs making contact
with the floor?
Is the power cord plugged into a properly grounded
3-prong outlet, which has been installed in accordance
with all applicable electrical codes?
Is the kickplate installed properly?
Is the door panel attached securely and properly
aligned?
Is the door aligned for proper appearance and
operation?
Have any installation or service problems been noted
on the product registration card? Has the registration
card been mailed in?
Has the stainless steel door been inspected for any
imperfections? This is to be done by the dealer or
installer with the customer upon completion of the
installation. Stainless steel panels are covered by a
limited 60-day parts and labor warranty for cosmetic
defects.
10