Replacing Fuel Filter; Every 500 Hours; Adjusting Engine Valve Clearance; Every After 1000 Hours - Kubota ZG327A-AU Operator's Manual

EVERY 400 HOURS
4. Remove the oil filter by using the filter wrench.
(1) Oil filter
(2) Restraining bolt
(1) Transmission oil filter (HST)
(2) Gasket
5. Apply a slight coat of oil onto the gasket of new
filter.
6. Tighten the filter quickly until it contacts the
mounting surface. Tighten filter by hand an
additional 1/2 turn only.
7. After the new filter has been replaced, the
transmission fluid level normally lowers a little. Add
fluid to proper level. Check for oil leaks around filter
gasket.
8. Return the bottom dust cover to the original
position.
IMPORTANT :
• To prevent serious damage or premature
failure to the hydraulic system, use only a
KUBOTA genuine filter.

3. Replacing fuel filter

Consult your local KUBOTA Dealer for this service.
ZG327A-AU

EVERY 500 HOURS

1. Adjusting engine valve clearance

If you do not have the proper tools and/or are not
mechanically proficient, consult your local KUBOTA
Dealer for this service.

EVERY AFTER 1000 HOURS

1. Cleaning combustion chamber

If you do not have the proper tools and/or are not
mechanically proficient, consult your local KUBOTA
Dealer for this service.
EVERY 1000 HOURS OR EVERY
1 YEAR
1. Replacing air cleaner primary
element and secondary element
(See Cleaning air cleaner primary element on page 60.)
IMPORTANT :
• To prevent serious damage to the engine, use
only a KUBOTA genuine filter.
How to remove the secondary element
1. While turning slightly, pull out the secondary
element.
(1) Secondary element

EVERY 1 YEAR

1. Checking fuel lines

If you feel you are unable to make the following service
correctly and safely, contact your local KUBOTA Dealer.
(See Checking the fuel filter on page 63.)

2. Checking hydraulic hose

If you feel you are unable to make the following service
correctly and safely, contact your local KUBOTA Dealer.
PERIODIC SERVICE
73