MOTION CONTROL LEVER
9. Adjust the other side equally.
10. After adjustment, make sure to stop the engine
immediately.
(1) Lock nut
(2) Speed control bolt
(1) Motion control lever
(2) Guide plate
3. Maximum speed (forward)
Consult your local KUBOTA Dealer for this service.
4. Motion control lever alignment
WARNING
To avoid serious injury or death:
• Park the machine on a firm and level surface.
• Stop the engine, remove the key and apply the
parking brake.
4.1 Checking the alignment
1. Check the gap and space between the levers at the
maximum forward position.
Recommendation
ZG327A-AU
(L) 50 mm (2.0 in.)
(A) "NEUTRAL" position (hands
off)
Gap: 0 to 2 mm (0 to 0.08 in.)
Space:10 to 20 mm (0.4 to
0.8 in.)
If the positions of the motion control levers are
unequal, adjustment is necessary.
(A) "GAP"
(B) "SPACE"
4.2 Aligning the motion control levers
1. Stop the engine and apply the parking brake.
2. Loosen the screws and remove the lever guide.
Lever position (high or low)
1. Remove the nut and select the motion control lever
position, high or low.
2. Tighten the nut.
In this figure, the motion control lever is set at the
low position.
(1) Motion control lever
(2) Nut
(3) Tab slot
Lever alignment (right and left)
1. Loosen the nut.
2. Slide both levers forward or rearward to the desired
position within tab slots until the levers are aligned.
3. Tighten the nut.
4. Install the lever guide with the screws and tighten
them securely.
NOTE :
• If the ends of the levers strike against each
other while in the "NEUTRAL" position, move
ADJUSTMENT
(A) High position
79