SCHUBERTH M1 Pro Manual page 51

Tip:
Changing the sun visor is easier when the chin section is open and locked
in place. It is also helpful if you place the helmet on a flat surface or on
your lap while seated.
Note:
Try to prevent the sun visor coming into contact with the helmet's inner
shell when removing or fitting it.
Removing the sun visor
1. Open and lock the chin section in place.
2. Pivot the sun visor down.
3. Bend the middle snap connection with
locating pegs gently outwards until the sun
visor is released from the visor holder.
4. Repeat this step for the other side.
Tip:
The sun visor holders should remain in the lower position while you install
the visor.
Fitting the sun visor
1. Put the sun visor between the snap
connections and fit it on to the locating pegs
on one side and then on the other.
2. Position the sun visor between helmet
inner and outer shell and lower it with the
operating slide.
3. For safety, check that the sun visor
mechanism is functioning correctly.
EN
49