How To Install The Power Plug; Power Switch - JUKI MO-6800S Series Instruction Manual

3-5. How to install the power plug

WARNING :
1. Be sure to attach the ground wire (green/yellow) to the specified location (on the ground side).
2. Take care not to allow terminals to come in contact with each other.
1ø 220-240V

3-6. Power switch

Single phase 220 to 240V
Blue
AC 220-240V
Brown
Green / Yellow
(ground wire)
❶
❶
– 7 –
1) Connect the power cord to power plug ❶ . Con-
nect the blue and brown wires (1ø) to the power
supply side and the green/yellow wire to the
earth side as illustrated in the figure.
1. Be sure to prepare the power plug ❶
which conforms to the safety standard.
2. Be sure to connect the ground lead
(green/yellow) to the grounding side.
2) Check that the power switch is in the OFF state.
Then, insert the power plug ❶ coming from the
power switch into the plug receptacle.
In prior to the connection of the power
plug ❶ , re-check the supply voltage spec-
ification indicated on the control box.
* The power plug ❶ is different in shape ac-
cording to the destination of the sewing ma-
chine.
1) Turning the power ON with the power switch ❶
The power to the sewing machine is placed in
the ON state when the "|" mark side of power
switch ❶ (1ø 220 - 240V type) is pressed; or in
the OFF state when the "0" mark side is pressed.
1. Do not strongly tap the power switch
by hand.
2. If the power indicator LED on the panel
does not light up after having turned
ON the power switch ❶ , immediately
turn OFF the power switch and check
the supply voltage.
When you want to re-turn ON power
switch ❶ after carrying out the afore-
mentioned steps, it is necessary to
wait for five minutes or more after you
have turned OFF power switch ❶ .
3. Do not place your hand or anything
under the needle since the needle bar
may automatically move according to
the memory switch setting when you
turn ON the power to the sewing ma-
chine.