JUKI MO-6800S Series Instruction Manual page 35

③ Selection of the presser foot lifting function (Function setting No. P16)
This is the function to select whether the presser foot is lifted or not when the back part of the pedal is
depressed.
* This selection is enabled in the case the presser foot lifting device is connected to the sewing machine.
(Refer to the Engineer's Manual for the detailed connection method.)
P16 0: The presser foot lifting operation is not carried out.
1: The presser foot lifting operation is carried out.
④ Selection of the suction function (Function setting No. P17 and No. P22)
This function setting is enabled when the suction device is connected to the suction 1 or 2.
(Refer to the Engineer's Manual for the detailed connection method of the suction 1 and suction 2.)
For each of the devices connected, the suction function can be separately selected.
P17, P22 0: Suction OFF
1: Front suction
2: Rear suction
3: Front and rear suction
4: Long suction
5: Intermittent suction (controlled by time)
6: Intermittent suction (controlled by the number of stitches)
* In the case "2: The needle stop position is not specified" is selected for the function setting number
"P02 Stop position selection", "6: Intermittent suction (controlled by the number of stitches)" cannot be
set.
⑤ Selection of the manual thread trimming function (Function setting No. P12 and No. P28)
This selection is enabled in the case the manual switch is connected to the sewing machine.
(Refer to the Engineer's Manual for the detailed connection method of the manual switch.)
The number of times of manual thread trimming can be selected.
P12 Setting range: 1 - 5 times
In addition, the suction function at the time of manual thread trimming can be selected.
P28 0: Suction OFF
1: The device connected to Suction 1 is operated
2: The device connected to Suction 2 is operated
3: Both devices connected to Suction 1 and Suction 2 are operated
(Refer to the Engineer's Manual for the detailed connection method of the suction.)
⑥ Production number counting function (Function setting No. P35 and P36)
This is the function to count the number of pieces produced.
P35 Number of pieces: 0 - 9999 pieces
In addition, the number of times of thread trimming to be carried out before adding one to the count num-
ber can be set.
P36 Setting range: 1 - 50 times
It is possible to carry out the sewing while the number of pieces is displayed.
If you want to reset the number of pieces to "0", keep
duced can be increased or decreased by pressing
❺ held pressed. The number of pieces pro-
❸ or ❹ .
– 33 –