Details Of Setting Of The Main Functions - JUKI MO-6800S Series Instruction Manual

6-5. Details of setting of the main functions

① Stop position setting (Function setting No. P02)
This function setting number is used for setting the stop position of the needle.
P02 0: The needle stops at its upper position
1: The needle stops at its lower position
2: The needle stop position is not specified
The needle stop position can also be changed with the relevant button on the operation panel.
The upper stop position and the lower stop position can be selected alternately by pressing
When the display B dot lights up, the needle stops at its upper position. When the display B dot goes out,
the needle stops at its lower position.
* In the case the function setting number "P02" is set to "2: The needle stop position is not specified" un-
der the function setting mode, the needle stop position is not specified regardless of ON / OFF of the
display B dot.
* In the case "6: Intermittent suction (controlled by the number of stitches)" is selected for the function
setting number "P17 Pedal control suction 1 type" or "P22 Pedal control suction 2 type", "2: The nee-
dle stop position is not specified" is not allowed to be selected.
② Selection of soft-start function (Function setting No. P03)
P03 0: Soft start OFF
1: Soft start ON
It is also possible to change the speed limit value for the soft start function and the number of stitches to
be sewn with the soft start function. (Function setting No. P04 - No. P05)
P04 Data settable range: 200 - 1500 [sti / min] <100 sti / min>
P05 Data settable range: 1 - 15 (stitches)
The soft-start function selection can also be changed with the relevant button on the operation panel.
The soft start OFF and ON can be selected alternately by keeping
When the display C dot lights up, the soft start ON is selected. When the display C dot goes out, the soft
start OFF is selected.
B
❺
❶
– 32 –
C
❸
❹
❷
❺ held pressed.
❺ .