Material And Hardness Scales Settings - DGC DHT- 200Plus Instruction Manual

-Press the
-Press the
-Press the
-Press the
Prompt: During measurements, the actual impacting direction must
conform to the one selected.

6.3.2 Material and hardness scales settings

During measurement performance, the material set must conform to the
actual measured material. DHT-200
materials for actual measurement. For each material, there is accordingly
different hardness scales. For details, please refer to appendix 2 and 3.
Before measurement, users should firstly confirm the measured materials
and the corresponding hardness scales. Set the proper materials and hardness
scales as following:
- Press the
- Press the
- Press the
- Press the
Hardness Tester DHT-200
key and the
key to enter this item,
key or key for setting,
key to confirm.
key and the
key to enter this item,
key or key for setting,
key to confirm.
PLUS
key to enter MEASURE- DIRECTION.
hardness tester supplies 9 kinds of
Plus
key to enter MEASURE- MATERIAL.
9