Storage Settings; Print File Settings - DGC DHT- 200Plus Instruction Manual

-Press the
-Press the
-Press the
-Press the

6.4.2 Storage settings

Set the data auto-saving state during measurement by turning on or off.
When data saving is set on "auto saving", there will be a corresponding
indication mark
the file automatically. Under this condition, the work piece mark can be set to
identify them in the same file, maximum 5 different work piece data can be
saved in one file.
-Press the
-Press the
-Press the
-Press the

6.4.3 Print file settings

Via this function, the saved data in instrument can be printed out. With this
function, users are allowed to print out data in a single file. Before printing,
users need to set the file code, start and end address of data stored.
Hardness Tester DHT-200
key and the
key to enter this item,
key or key for setting,
key to confirm.
on the screen, and the measuring values will be stored in
key and the
key to enter this item,
key or key for setting,
key to confirm.
PLUS
key to enter FILES--SETUP NEW FILE,
key to enter FILES--SETUP STORAGE,
11